Help installing my amp?

[StigmataPartIII]

Listen, I just got my 2-channel 800watt amp replaced because the one i ordered before had a bad coil. I have my new one now and i need to plug all the wires back into the amp (the amp kit is already installed) can somebody give me step by step instructions on all the plug-ins, I rather not pay 50 bucks for a 30 minute job. Appreciate it.

[Verz]

make sure the ground wire is attatched to a metal surface somewhere on the car, the remote and rca is correctly attached to the deck and the power wire terminal is connected to the battery. hook up the ground(usually brown), the remote wire(blue) the powere wire(red) to the amp and than insert the fuse into the amp an than the one for the power cord. there ya go simple as that.

[StigmataPartIII]

good lookin. do i need those wishbone shaped connectors when hooking up wires to the amp?

[Existenz]

Be sure that you ground your amp to an unpainted metal surface on your vehicle's body. Also be sure to run your rca cables on the opposite side of the vehicle then your power cable, this will reduce noise. Be sure to fuse your power cable under the hood with the recommended fuse size, do this no further the 12" away from your battery.. These are a couple of important things that were not mentioned..

[Verz]

hmm did not know that bout the rca and power cord

Originally Posted by StigmataPartIII

good lookin. do i need those wishbone shaped connectors when hooking up wires to the amp?

Not neccesarily(sp) itll make it easier if you decide to relocate the amp or need to rerun the wires, and it should give you a better connection, but its not a mandotory thing.

[BestMovieMen]

no advertising